Tools Required: 1 Power drill, corded or cordless

Take your two wires and insert them into the drill where you would normally place the bit and tighten it up.



Place the other end of the wire in a vice, or hold it tight in your other hand, so that there is no slack while slowly pressing the trigger on the drill. It will twist the wires good and tight and you will end up with something like this...

You know a lot of stuff about building computers huh?

Nice

I actually got the idea from someone else, but it works non-the-less the same way they did it.

In all reality i saw it done on "How its made" on the discovery channel, they were making twisted cables for networking, and basically had a wall of drills that twisted some 300 cables at once.

haha good shit bv

a common sense tutorial XD